With the cost of quarried aggregates steadily increasing and the
quality of recycled products dramatically improving, recycling of inert
materials are now an excellent cost effective alternative. We produce a
variety of aggregate, soil and infill products from our recycling
facility, for use on construction and landscaping projects, we can
deliver single loads from 15 tonnes up to major volumes on to
construction sites, alternatively you can uplift small quantities from
our depot.
Recycled Products Available
200mm Primary Bottoming
200mm down crushed product, ideal for making up large areas of unstable
ground prior to spreading smaller materials on top.
100mm Crusher Run
100mm down crushed product used for base or capping layer on hard
standing areas or access roads, due to its size, grading and levelling
is relatively easy and this material also compacts well.
Type 1 Sub base
35mm down crushed and screened product used for capping roads, car
parks and yard areas etc, spreads and compacts well also seals due to
the amount of fines in this material.
100 – 50mm Clean
This product is manufactured from the milled surface of a tarmac road
or from dug tar being crushed, a vary hard wearing product that can
easily be compacted, ideal for the use on access tracks, car parks,
yards or hard standing areas.
Infill
A general fill material mostly sandy / sub soily fines produced from
the fines belts of our crushing and screening plant, used for making up
large areas of ground where aggregate products would prove to costly.
Topsoil (Screened)
Good quality topsoil that has been screened using 35mm elongated mesh,
so that your finished topsoil product has no larger stones than 35mm
which is ideal for gardens, lawns, embankments and all other gardening
/ landscaping projects where little or no stone harrowing is required
before grass seeding.
Topsoil (Unscreened)
An unprocessed topsoil, straight from the area of excavation, used for
large areas of topsoiling, not recommended for turfing unless the
surface area is large enough to be harrowed to a fine tilth.
Most other products can be made upon request, please do not hesitate to
contact us to discuss your requirements further contact: 01330 830033
Frank, Alan, Ian
